|
| |
Contents | Index
Show Other Lines
- Low Spec, Nominal, High Spec Check on any of these boxes if you want a line to be displayed at the
corresponding value on a Process Capability Chart, Run Chart or an Individual-X
chart.
- Lower Control Limit, Average, Upper Control Limit Check on any of these boxes if you want a line to be displayed at the
corresponding value on a Process Capability Chart or an Individual-X chart. The
Average value is displayed (m=xxx) on the Process Capability Chart when Average is selected.
- Zone Lines Check on this box to draw lines at 1, 2, and 3 standard deviations on each
side of the mean on X-bar / Range, X-bar / Sigma, Individual-X (normal curve fit
only), and Process Capability (normal curve fit only) charts.
|
